DOMINATOR Platinum RGB DDR4 8x16GB

One Corsair DOMINATOR PLATINUM RGB DDR4 memory module (one 16 GB stick of kit CMT128GX4M8X3800C19), scanned on our rig. MOST IMPORTANT: THE MODULE MUST FIT A STANDARD DDR4 DIMM SLOT. Its edge connector must insert straight down into a DDR4 slot, key aligned, fully seated, with the slot's latches closing into its side notches. The edge and its collision must be thin enough to enter the slot channel. THE SPECS ARE GROUND TRUTH. Where the reference mesh, photos, video or any measurement disagree with the manufacturer documents below, follow the documents. The scan, photos and video are for appearance, overall shape and anything the documents do not cover. Sources: Corsair product page https://www.corsair.com/us/en/p/memory/cmt128gx4m8x3800c19/dominatora-platinum-rgb-128gb-8-x-16gb-ddr4-dram-3800mhz-c19-memory-kit-cmt128gx4m8x3800c19 ; Corsair DDR4 module dimensions https://www.corsair.com/us/en/explorer/diy-builder/memory/ddr4-memory-module-dimensions/ (DOMINATOR PLATINUM RGB: 135 mm long, 8 mm wide, 56 mm tall overall). DDR4 288-pin UDIMM edge (JEDEC MO-309; Micron/Crucial drawing, p.17 of https://docs.rs-online.com/6ecf/0900766b81641250.pdf): PCB 133.22-133.48 mm long (nominal 133.35), 1.3-1.5 mm thick at the gold fingers, 0.85 mm contact pitch, 0.60 mm contacts, first contact 3.35 mm from each end; one off-centre key notch (0.75 mm radius) splitting the contacts into a 64.6 mm run (77 contacts, pin-1 end) and a 56.10 mm run (67 contacts) with a 5.95 mm gap, i.e. about 71-72.25 mm from the pin-1 end (the drawing's front view says 72.25); two side latch notches (3.0 mm) at each short end, 9.5 and 16.1 mm above the contact edge; 1.25 mm x 45 deg chamfered top corners. Build the PCB edge, gold fingers, key notch and latch notches exactly to these numbers. The heatspreader follows Corsair's 135 x 8 x 56 mm overall size: two black heatspreader plates over a 10-layer PCB (Corsair), with the light bar (12 CAPELLIX RGB LEDs per Corsair) along the top edge. The gold-finger ed